technical characteristics
COMBINED STONE AND GLASS

1. TECHNICAL SPECIFICATIONS AND USE.

• Low resistance to chemical attack.
• Dimensional tolerance of the ceramic base: +0.6%
• Good resistance to attack by microorganisms.
• Best used for indoor cladding.
• Shades of colour vary.
• Do not store in damp areas.

2. SURFACE PREPARATION.

• The wall to be clad must be perfectly clean, dry and flat.

3. FIXING MATERIAL.

• Use C2 thin set or epoxy adhesives for perfect adherence. Read manufacturer’s instructions carefully.

4. PLACEMENT.

• Spread a thin layer of adhesive on the surface and place the stone before the adhesive starts to harden.
• Use a damp sponge to remove excess adhesive before it hardens.

5. POINTING AND CUTTING.

• Make sure the adhesive is completely dry before pointing.
• Read the paste manufacturer’s instructions before pointing.
• Use a damp sponge and water to remove excess paste.

6. CLEANING AND UPKEEP.
• Use a sponge and water or neutral detergents.
• Do not use abrasive and anti-calc products.
PRECIOUS STONES

1. TECHNICAL SPECIFICATIONS AND USE.

• Low resistance to chemical attack.
• Used only for cladding.
• 100% natural.
• Broad range of shades, colours and sizes.

2. SURFACE PREPARATION.

• The wall to be clad must be perfectly clean, dry and flat.
• We recommend painting the wall white to make the adhesive as invisible as possible.
• Waterproof the wall before cladding in wet areas.

3. FIXING MATERIAL.

• We recommend using H40 material, since it can serve as a combined fixing thin set and pointing paste.

4. PLACEMENT.

• The material must be perfectly clean and dry on both sides, where it comes into contact with the adhesive and on the front face.
• Place the parts close together, touching, without leaving space for the pointing.
• Spread the adhesive along the edges and in the middle of the piece.
• Place the piece and then slide it a bit on the wall to fill in the hollows.
• If you find a hollow between the meshes after placement, cover them with loose pieces for a good finish.

5. POINTING AND CUTTING.

• Use standard pointing paste if you prefer pointing the finish.

6. CLEANING AND UPKEEP.

• Use a sponge and water or neutral detergents.
• Do not use abrasive and anti-calc products.

SPECIFICATIONS

METALS.

Do not place on normally wet surfaces.

RESINS.

Recommended for interiors. Do not expose to direct sunlight for long periods.

PAINTED STONE.

To clean, wash with a damp cloth. Do not use abrasive material.

ECO NATURAL.

Recommended for interiors. Not apt for long-term contact with water.